We are pleased to announce the successful completion of a lab-scale pilot demonstration of our proprietary nano-porous sorbent, utilizing a moving bed temperature swing adsorption capture unit, simulating Waste-to-Energy flue gas conditions.
This accomplishment marks the advancement of our DotzEarth’s Technology Readiness Level (“TRL”) to TRL 4-5, a significant step forward on the path toward market viability.
Dotz CEO, Sharon Malka said: “The achievement of TRL 4 lab-scale demonstration for DotzEarth is a significant step forward on the path towards the technology’s commericalisation.

“We are very excited about the results of the lab-scale runs, which corroborate the results previously achieved in validation testing and process simulations, and confirm the potential of DotzEarth as a viable, cost-effective solution for hard-to-abate industries.
“This lab-scale pilot testing program was specifically designed to verify and validate the performance of our proprietary nano-porous sorbent. The fact that we see such high recoveries in this continuous flow system is incredibly encouraging as we now look towards the next scale up of our technology, process design of a modular, mobile small-scale pilot.
“Dotz would again like to acknowledge the support provided by SINTEF in undertaking these trial runs. We have been working very closely with SINTEF for a year now, and are looking forward to continuing our partnership through another round of technology demonstration”.
DotzEarth, Dotz’s proprietary nano-porous carbon adsorbent, represents a new generation sorbent technology for CO2 capture. Dotz’s innovative nano-porous carbon adsorbents have demonstrated multiple advantages such as high working capacity, fast kinetics, increased selectivity and lower regeneration energy.

The sorbent was process tested at SINTEF’s lab, a leading climate technologies research organization. The testing was conducted on SINTEF’s Moving-Bed Temperature Swing Adsorption (MBTSA) TRL-4 pilot unit, simulating Waste-to-Energy flue gas conditions.
The lab-scale pilot testing was operated at defined process conditions, according to an adsorbent benchmarking protocol defined by SINTEF. The pilot operating demonstrated the superior results of the Dotz sorbent when compared with a commercial activated carbon sorbent. Most importantly, use of the Dotz nano-porous sorbent yielded higher adsorption capacity, and higher in situ desorption purity relative to the commercially available sorbent. In addition, stable performance of the Dotz sorbent was demonstrated over approximately 140 desorption/adsorption cycles.
These results corroborated the previous process simulation results conducted by SINTEF and validated the potential to significantly drive down the cost of CO2 capture.
A number of process optimization opportunities have been identified to further enhance the performance of the MBTSA unit with the Dotz adsorbent. These opportunities will be developed with Dotz’s strategic development partners, and it is planned to be incorporated into the basis of design for the small-scale modularized and mobile pilot. Dotz plans to use the mobile pilot at different industrial sites with varying flue gas conditions in order to optimize the Dotz adsorbent and CO2 capture process offering for specific industrial applications.